I have a bunch of old sawblades to cut...and different sizes circle blanks
Wanting my plasma table to recognize the center of the drawing as orientation instead of the bottom left corner...
I am sure its a simple button I am missing to do this.
Help appreciated. Thank you
sawblades center orientation
-
- 1 Star Elite Contributing Member
- Posts: 31
- Joined: Sat Mar 29, 2014 9:18 pm
sawblades center orientation
LDR 5x10 table
Hypertherm PM 85
Sterling Cool Plasma Juice
Hypertherm PM 85
Sterling Cool Plasma Juice
- djreiswig
- 4.5 Star Elite Contributing Member
- Posts: 2020
- Joined: Thu Nov 19, 2015 10:02 pm
- Location: SE Nebraska
Re: sawblades center orientation
If you use SheetCam, you just center the part on 0,0. Then zero your torch on the center of the blade.
If not, I'm sure there's a similar procedure.
If not, I'm sure there's a similar procedure.
2014 Bulltear (StarLab) 4x8
C&CNC EtherCut
Mach3, SheetCam, Draftsight
Hypertherm PM65
Oxy/Acetylene Flame Torch
Pneumatic Plate Marker, Ohmic, 10 inch Rotary Chuck (in progress)
C&CNC EtherCut
Mach3, SheetCam, Draftsight
Hypertherm PM65
Oxy/Acetylene Flame Torch
Pneumatic Plate Marker, Ohmic, 10 inch Rotary Chuck (in progress)
-
- 4.5 Star Elite Contributing Member
- Posts: 1829
- Joined: Mon Jun 12, 2017 6:43 pm
Re: sawblades center orientation
if you scroll down to step 3 and follow the instructions and select your import origin
https://www.avidcnc.com/support/instruc ... Toolpaths/
https://www.avidcnc.com/support/instruc ... 3_Zoom.png
https://www.avidcnc.com/support/instruc ... Toolpaths/
https://www.avidcnc.com/support/instruc ... 3_Zoom.png