Feedrate
-
- 1/2 Star Member
- Posts: 9
- Joined: Fri Feb 22, 2019 7:00 pm
Feedrate
Can I change the feedrate without having to go back into sheetcam and change if I decide it’s too slow or too fast while cutting?
-
- 3.5 Star Member
- Posts: 681
- Joined: Wed Nov 26, 2014 5:12 pm
Re: Feedrate
You haven't posted what software you're running.
Mach3 you click on edit Gcode then look for F code and change them all to whatever speed you want.
Mach3 you click on edit Gcode then look for F code and change them all to whatever speed you want.
-
- 1/2 Star Member
- Posts: 9
- Joined: Fri Feb 22, 2019 7:00 pm
Re: Feedrate
This is posted in the Mach3 section but thank you so much
- acourtjester
- 6 Star Elite Contributing Member
- Posts: 8131
- Joined: Sat Jun 02, 2012 6:04 pm
- Location: Pensacola, Fla
Re: Feedrate
YOu can move the green slider up and down on the fly, but changing the feed rate in the G-code is better, and it would be there the next time you cut that G-code.
DIY 4X4 Plasma/Router Table
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
-
- 3.5 Star Member
- Posts: 681
- Joined: Wed Nov 26, 2014 5:12 pm
Re: Feedrate
I wasn't paying attentionodaydayday wrote: ↑Thu Mar 28, 2019 7:20 am This is posted in the Mach3 section but thank you so much