I tried to use Ref Z in Setup but it was literally shooting my tip into the table. I haven't figured out how to raise it. Please help.
SOVLED: PG UP + SHIFT
How Do I Manually Control Torch Height?
-
- 1 Star Member
- Posts: 16
- Joined: Fri Mar 25, 2016 9:25 am
- acourtjester
- 6 Star Elite Contributing Member
- Posts: 8134
- Joined: Sat Jun 02, 2012 6:04 pm
- Location: Pensacola, Fla
Re: How Do I Manually Control Torch Height?
If you are using Mach 3 you will need to go into ports and pins under input signals and dis-able all of the X+ - and home, Y +, -, and home, and z+, - home. Then hit reset to get it to stop blinking, Then use the page up button on the keyboard or hit the TAB key (this brings out the pendant) move the mouse over Z- and click on the mouse left key until the torch moves up. Then learn never hit Z ref again. On a plasma table you should only ref X and Y not ref all.
DIY 4X4 Plasma/Router Table
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
-
- 1 Star Member
- Posts: 16
- Joined: Fri Mar 25, 2016 9:25 am
Re: How Do I Manually Control Torch Height?
Haha thank you. Got it.