Which post processor to use

[Rampage48]

I am currently running a Bladerunner Dragon Cut system with DTHC II (rev 1.3) it was bought in 2012. I had been using it for a couple years and stopped for a year and am now getting back into it, at that time I was using (Plasma MP1000-THC -ZRef post processor). I have recently installed the new MasterInstaller X Legacy from the CandCNC website and the Support Files Latest SheetCAM TNG (version 6.0.1 or later) with DCC upgrade, I would like to be able to take advantage of some of the code snippets especially DTHC on/off. Will the new toolsets included with this work for me?

What post should I be using now with my system?

Can I use the DTHC-HYT-TAP_SoftPierce+Marker post that I see now in the new posts?

Thanks

[acourtjester]

Go to the CandCNC web site form and post your question there but Tom seems to check here so he may answer here too.