Metal cleaning

Learn and share dross removal techniques, experiences, and product knowledge here.
Post Reply
exceptional
2 Star Member
2 Star Member
Posts: 65
Joined: Tue Jun 24, 2014 10:24 pm

Metal cleaning

Post by exceptional »

I have watched videos, but when I powder coated my piece, it has some flaws. I'm still not sure about the clean up of metal to prepare it for patina or powder coating finishes. Is dipping it in acid enough, or do I need to pull it out and sand it down with 120 grit? looking for that flawless metal to finish up. Getting into patinas in about a week and would like to have my foundations sets before running into problems. Thanks for your time.
User avatar
tnbndr
4.5 Star Elite Contributing Member
4.5 Star Elite Contributing Member
Posts: 1688
Joined: Mon Jan 09, 2012 4:30 pm
Location: New Berlin, WI
Contact:

Re: Metal cleaning

Post by tnbndr »

Watch the videos on Steel FX site for clean up. Basically after acid dipping to get rid of mill scale you need to grind with 120 grit disc to get shiny metal for patinas.
As for powder coating, it won't hide defects so I would at minimum do the same prep.
Dennis
LDR 4x8, Scribe, DTHCIV
Hypertherm PM45, Macair Dryer
DeVilbiss Air America 6.5HP, 80Gal., 175psi, Two Stage
16.9scfm@100psi, 16.0scfm@175psi
Miller 215 MultiMatic
RW 390E Slip Roll (Powered)
AutoCAD, SheetCAM, Mach 3
http://ikescreations.com
exceptional
2 Star Member
2 Star Member
Posts: 65
Joined: Tue Jun 24, 2014 10:24 pm

Re: Metal cleaning

Post by exceptional »

Perfect, thank you.
bndave
1/2 Star Member
1/2 Star Member
Posts: 2
Joined: Sun Jul 13, 2014 6:10 pm
Location: Utah

Re: Metal cleaning

Post by bndave »

i find that sanding and sometimes buffing will clean up the steel for powder coat well

You currently do not have access to download this file.
To gain download access for DXF, SVG & other files Click Here

User avatar
AnotherDano
4 Star Member
4 Star Member
Posts: 802
Joined: Fri Dec 18, 2009 11:52 pm
Location: Laramie, Wyoming
Contact:

Re: Metal cleaning

Post by AnotherDano »

I use a belt sander with 50 grit to provide lots of 'tooth'.

Then using a pressurized sprayer, the piece is drenched with alcohol (very fine spray) until there are no 'breaks'.
Using a clean 3" paintbrush, remaining alcohol is brushed away and the piece is torched to remove any fuzzies.

Then I coat it.

Dano
Dano Roberts
droberts@ironpequod.com
PlasmaCam DHC-2 v3.11
Hypertherm PowerMax-30
Serving Laramie, Wy since Thursday
Post Reply

Return to “Dross/Slag Removal”