Garden Sun
- Metal Troll
- 2 Star Member
- Posts: 82
- Joined: Wed Sep 23, 2009 12:06 pm
- Location: Phoenix Arizona
Garden Sun
Well I finally got a picture of my sun that i did. So here it is
- Attachments
-
- Sun.jpg (183.47 KiB) Viewed 1879 times
- Sun.jpg (183.47 KiB) Viewed 1879 times
-
- 2 Star Elite Contributing Member
- Posts: 69
- Joined: Sun Jul 26, 2009 2:03 pm
Re: Garden Sun
AHHHH My eyes!!!!!
I think I burnt my eyeballs staring at your Garden Sun too long.
Very nice work.
It's hard to see through my burning orbs, but are those squiggly detail cuts with the background showing through on your sun?
I think I burnt my eyeballs staring at your Garden Sun too long.
Very nice work.
It's hard to see through my burning orbs, but are those squiggly detail cuts with the background showing through on your sun?
- Metal Troll
- 2 Star Member
- Posts: 82
- Joined: Wed Sep 23, 2009 12:06 pm
- Location: Phoenix Arizona
Re: Garden Sun
Its not the best picture so its kind of hard to see. The sun rays and black border are all 1 pc of 14ga hot rolled that i ground on for hours and behind the face i tac welded a light gauge pc of galvanized that i put a swirl pattern on. then around the the outside edge on the back side i welded 1/2 square tube steel along with some brackets to hang it if desired.
I learned my lesson on this one about trying to use hot rolled instead of cold rolled. The grinding was crazy and took forever to get it so i could torch it.
I learned my lesson on this one about trying to use hot rolled instead of cold rolled. The grinding was crazy and took forever to get it so i could torch it.