I am having a problem with the torch slightly dragging on the metal while cutting. I am cutting 14ga. I do believe my plasma setting are right. Using fine cut consumables @ 40 amps Pierce ht is .015 started cutting at .06 did change to .09. Still dragging. cut is not bad, just have to clamp metal down and hope for the best
Plasma Route 4 x 4
Hyperthem Powermax 65
THC 301
TORCH DRAGS WHILE CUTTING
-
jmsrbrt
- 3 Star Member
- Posts: 383
- Joined: Mon Dec 08, 2008 5:24 pm
- Location: San Marcos, TX
- Contact:
Re: TORCH DRAGS WHILE CUTTING
Raise your voltage?
Torchmate 2 with ATHC & Water table
Corel 12, Turbo Cad
TD Cutmaster 51
San Marcos, Texas
Corel 12, Turbo Cad
TD Cutmaster 51
San Marcos, Texas
-
SAWMILL
- 1/2 Star Member
- Posts: 9
- Joined: Tue Jul 03, 2012 5:51 pm
Re: TORCH DRAGS WHILE CUTTING
That was it. Voltage too low. Thanks
-
jimcolt
- 5 Star Elite Contributing Member
- Posts: 3087
- Joined: Mon Jul 20, 2009 11:18 pm
- Location: North Carolina
Re: TORCH DRAGS WHILE CUTTING
Always adjust the voltage until the cut is at the recommended height...which in this case should be .06"
Jim
Jim
SAWMILL wrote:I am having a problem with the torch slightly dragging on the metal while cutting. I am cutting 14ga. I do believe my plasma setting are right. Using fine cut consumables @ 40 amps Pierce ht is .015 started cutting at .06 did change to .09. Still dragging. cut is not bad, just have to clamp metal down and hope for the best
Plasma Route 4 x 4
Hyperthem Powermax 65
THC 301
