In order to draw this panel correctly, you need to provide dimensions '
a' through '
r'
I will assume this panel screws to another component, so the screw holes MUST match up on both the X and Y dimensions.
I will assume that the components that fit into the six rectangular holes must fit into the holes, and therefore the holes cannot be drawn to match the photo, but must be sized correctly to fit the existing components that will snap into those holes.
I will assume that holes for the components that fit into the one round hole, the two additional shapes with a radius on the top and bottom, and flat vertical sides, and the six round holes with flat tops and bottoms, and radius sides must all fit the existing components that will be inserted into them, as none of these components can be scaled to fit improperly drawn holes.
So all of the dimensions in the attached photo must be known, in order to draw this panel correctly.
Joe
Plasma:
PlasmaCam 4x4, Samson 510 table, Go Torch, + more
AD-AH-AM-AN-3D-CS-MU-PC - Upgrades
Lasers:
X-TOOL D1 PRO (x 4) F1, S1 (x3), P2 (x2), F1 ULTRA (x2) with conveyors, M1 ULTRA (x2) + accs.
LaserPecker 1 PRO, LP-2, LP-4 + accs
50 Watt GALVO fiber
TYVOK Spider S1 60W Diode Laser 49" x 96"
3D Printers:
CreatBot D600 PRO
Stratasys Fortus 400mc
BIGREP Studio Gen 2
MODIX Big Meter
Why pay off debt when you can die owning
MILLIONS?
FREE DesignEdge Training Online Via ZOOM!