Motion pauses randomly on straight sections

Post by **acourtjester** » Fri Sep 20, 2024 12:56 pm

I have been working with another DIY guy on some problems with his start up. His table is cutting now but it has a odd movement problem and I cannot come up with an answer. It looks like a mechanical problem but does it in the X and Y directions, not like slipping. When cutting is seems to pause while cutting a straight line. The video shows cutting a rectangle and it pauses on the 4 side cuts, not when changing directions!!!!
Any theories??

IMG_2673.mp4: (8.56 MiB) Not downloaded yet

IMG_2673.mp4: (8.56 MiB) Not downloaded yet

Post by **Joe Jones** » Fri Sep 20, 2024 1:18 pm

It sounds like you are cutting four individual paths, rather than a single closed path.

Joe

Post by **acourtjester** » Fri Sep 20, 2024 3:59 pm

Forget it he said he reloaded Mach and it now does not pause. This remote troubleshooting has its limits, he is far way from me.

Post by **adbuch** » Fri Sep 20, 2024 5:00 pm

acourtjester wrote: ↑Fri Sep 20, 2024 3:59 pm Forget it he said he reloaded Mach and it now does not pause. This remote troubleshooting has its limits, he is far way from me.

Great effort on your part Tom!! Happy to hear he is up and cutting again.
David

Post by **acourtjester** » Fri Sep 20, 2024 11:05 pm

Thanks happy to help, keeps the old gray matter active.

Motion pauses randomly on straight sections

Motion pauses randomly on straight sections

Re: What do you think about this problem

Re: What do you think about this problem

Re: What do you think about this problem

Re: What do you think about this problem