Ohmic Sensing with Relay Modules
-
wonder1
- 1/2 Star Member
- Posts: 1
- Joined: Thu Dec 28, 2023 3:08 pm
Ohmic Sensing with Relay Modules
Looking for some feedback on this wiring diagram for Ohmic sensing using 2 opto-isolated relay modules. I'm using a Mesa 7i96s and a Hypertherm PowerMax 1000 plasma cutter. I based the drawing mostly from the CNC Plasma primer on the Linux CNC website, but redrew it to match the relays I am using. It is working as it should, but wanted to get a second look before I started cutting with it.
-
acourtjester
- 6 Star Elite Contributing Member
- Posts: 8131
- Joined: Sat Jun 02, 2012 6:04 pm
- Location: Pensacola, Fla
Re: Ohmic Sensing with Relay Modules
I have been using a similar circuit with LinuxCNC and other electronics, and it works great. I am using a 7I76E card but I'm sure yours will work the same. They make those modules in different voltages I used 12 volts on mine.
DIY 4X4 Plasma/Router Table
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
