Complete Controller with PC

[teerosk]

Complete plasma / router controller with PC with the software and hardware installed. I pulled this from a 2021 Shop Sabre Sidekick 12. All of the motor axis and limit switch wires are labeled for easy reinstall. This was ran with clearpath servo motors. It is pretty much ready to be plugged into your motors and limit switches. Everything in the photos is what you will get.
I can ship it to you at your expense. It is located in Pittsburgh, Pa if you want to arrange a pickup.

$1500 + shipping

All items included:

WinCNC
PC Tower
- Windows 10
- WinCNC Software with Plasma and Router Support
- Handheld Wireless Keypad Support

Complete Controller
- Plasma THC
- 5 Axis Support
- Air Scriber Support
- Tool Setter Support
- Warning Light Bar Support

Wireless Keypad
-Software Supported

- Plasma mount with Collision Detection

[adbuch]

It's too bad you didn't take some video of it running the table before you disassembled it. At this point, a prospective buyer has no way of knowing if it is fully functional or not. Good luck!!

David