EasyScriber For Flashcut Software

[claudio]

Hey everyone,

I did a search for easyscriber for flashcut cnc and couldn't find any info , so through trial and error ( tons of error ) I finally figured out how to use it.

I have attached some photos of the setup and and will type some info as well.

Step 1 is to open up flash cut ( I use Silver cut from machitech ) and go to configuration ( top right , 2 gears beside key )

Step 2 On the left hand side, click Fabrication heads

Step 3 New Fab Head

Step 4 Enter same as screen shots

Hope it works , let me know if it helped

[EasyScriber]

Thanks for posting your setup. Flashcut is not one that we have worked personally with and your setup is appreciated. Glad you have it set up and working, please keep us posted on your success with this.

[ejmetalworks]

Did you figure out how to solid fill letters with the easyscriber?

[EasyScriber]

Did you figure out how to solid fill letters with the easyscriber?

We can help you fill your letters. Do you use Inkscape? If not what software do you do your design work in?

[ejmetalworks]

I did it with Inkscape. Flash cut hasn’t added a hatch fill option yet but hopefully they will soon.

[EasyScriber]

I did it with Inkscape. Flash cut hasn’t added a hatch fill option yet but hopefully they will soon.

Great, glad you were able to make it happen.

[adbuch]

I did it with Inkscape. Flash cut hasn’t added a hatch fill option yet but hopefully they will soon.

ejmetalworks - thanks for sharing this information! I use Inkscape for hatch fill as well. You instructions for setting up the EasyScriber for Flashcut will be much appreciated by other Flashcut users.

David