Looking for a schematic.

Post by **abmetal** » Sat Feb 25, 2023 11:49 am

Years ago (2010) I hardwired my HP PM65 to our new Samson table. Since we've closed the business, I now would like to change it to use a plug so I can quickly separate it from the table. Problem is I can't find my original wiring diagram AND my old brain doesn't work the way it used to. Would anybody have a diagram of how the new plug needs to be wired? I thought that it might just be simpler to put in a four pin plug where it goes in at the bottom of the unit. I know this is easy peasy for a lot of folks but unfortunately, not for this bumpkin. Opinions?

Allen

IMG_7979.jpg

IMG_7975.jpg

IMG_7978.jpg

IMG_7977.jpg

Post by **Joe Jones** » Sat Feb 25, 2023 1:17 pm

Robert Johnson can answer this question.

Joe

SegoMan DeSigns · Post by **SegoMan DeSigns** » Sat Feb 25, 2023 1:19 pm

Here is the download section for the 65, I would save them all to disk for future use:

https://www.hypertherm.com/en-US/resour ... ish%20(US)

Looking for a schematic.

Looking for a schematic.

Re: Looking for a schematic.

Re: Looking for a schematic.