hello I am trying to sell y table frame and torchmate height controller to a local guy. I am upgrading to a fab cut gantry and swapping my electronics in. The guy wants to buy my avhc, table and software but wants me to find a controller and motors that will work with the torchmate AVHC(wedge shaped box). Any suggestions that would work I contacted motion tech they said they could set me up with a controller but didn't know if there Mach 3 and controller would work with the AVHC. If I can pull off the sale it will almost cover the cost for me to upgrade my software to flash cut with the software controlled AVHC and Ohmic sensing and router control. Thanks for the help.
Something from Canada if possible.
cnc controler that will work with torchmate AVHC
-
- 1 Star Member
- Posts: 15
- Joined: Tue Jul 01, 2014 10:34 am
-
- 5 Star Elite Contributing Member
- Posts: 2713
- Joined: Thu Jul 24, 2008 11:15 am
Re: cnc controler that will work with torchmate AVHC
That's a tall order but I would contact C&CNC, if anyone can help you out it will be them.
- modelaratrod
- 2 Star Member
- Posts: 86
- Joined: Tue Jul 23, 2013 12:41 pm
- Location: Colorado
Re: cnc controler that will work with torchmate AVHC
5x10 Torchmate 2 w/AVHC
Hypertherm PM85 w/ machine & hand torch.
Hypertherm PM85 w/ machine & hand torch.
-
- 1 Star Member
- Posts: 15
- Joined: Tue Jul 01, 2014 10:34 am
Re: cnc controler that will work with torchmate AVHC
thanks I will look into it