Laptop & Mach 3
-
- 1/2 Star Member
- Posts: 2
- Joined: Sat Mar 09, 2019 1:42 pm
Laptop & Mach 3
Does anyone run their table with a laptop and Mach 3
- acourtjester
- 6 Star Elite Contributing Member
- Posts: 8134
- Joined: Sat Jun 02, 2012 6:04 pm
- Location: Pensacola, Fla
Re: Laptop & Mach 3
If I remember correctly there has been some problems with laptop use but I think it was with using the parallel port on the Laptop. It was about the signal strength from the Parallel post. I used a Laptop on my daughters table but it was with the USB port and Mach 4. And another table when using a USB BOB it had a separate power supplies. The USB powered the Motor signal portion but the separate power supply was for the home/limit switches and the relay trigger output section using Mach 3.
DIY 4X4 Plasma/Router Table
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT