Hey, I am new to all this. I am using a CandCNC BladerunnerAIO-DTHC-UBOB3-Rev15, Sheetcam, Mach 3 and Hypertherm 45. The paperwork that came with machine says to use the MP3000 post, but when I go to cut the THC dives down into the material, is this the correct post? or is there another one out there and where? I tried using the CandCNCPlasma-rev11m1 post, but it would turn the torch on and pierce than not move at all. Any and all help would be appreciated for this rookie.
Thanks in advance!
Sheetcam Post
-
acourtjester
- 6 Star Elite Contributing Member
- Posts: 8134
- Joined: Sat Jun 02, 2012 6:04 pm
- Location: Pensacola, Fla
Re: Sheetcam Post
For the torch diving you may want to put this delay in the tool setting it holds the DTHC off until it has a more stable voltage.
not sure about the second problem have you gone to their wed forum and posted the question there, they have answered my questions there.
not sure about the second problem have you gone to their wed forum and posted the question there, they have answered my questions there.
- toolseting.jpg (32.32 KiB) Viewed 585 times
- toolseting.jpg (32.32 KiB) Viewed 585 times
DIY 4X4 Plasma/Router Table
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
