corel draw help
-
- 1 Star Member
- Posts: 14
- Joined: Sun Aug 30, 2015 6:27 pm
- Location: Ontario, Canada
corel draw help
hey guys drew this last night looked really good to the eye.Went to cut it and when it came around to the left side of the numbers the cnc jmissed its cut almost by an inch.Can anyone tell me why.
- Attachments
-
- snow gauge finish1.cdr
- (62.96 KiB) Downloaded 93 times
- snow gauge finish1.cdr
- (62.96 KiB) Downloaded 93 times
-
- 1/2 Star Member
- Posts: 2
- Joined: Mon Jan 28, 2013 7:14 am
Re: corel draw help
Drawing is too close to edge.you must allow at least 2.5mm for torch
- Team Tracker
- 2.5 Star Member
- Posts: 104
- Joined: Thu Nov 18, 2010 7:36 pm
Re: corel draw help
The left side of your gauge has over extending lines which could be causing you problems also. See image below where I have circled, there may be more so you will have to zoom in close to find these. Fix this issue up and try again.
1-800-590-7804