Need to contct Les to get on SC help forum

[Largemouthlou]

Just hooked up a new to me computer and Candcnc blade runner dthc2 hooked up floating head and changed switch offset in my old post processor. Zero out dro when Ft sensor lights up and hit run. The torch height is .50 higher then dro is reading.

Is there a special post possessor?? Motors are tuned correctly (same as old computer). Figured I would start with post processor and work down. When the Z dro says 1" it is actually 1.5 above material.. I don't see it in the G code but figured I would ask.

Tried to get on SC help board and said I'm inactive and won't accept my info.

[davek0974]

I have an MP3000-DTHC2 from CandCNC and yes it has custom posts and screens for Mach3.

Its all the in the master installer disk/download

[Largemouthlou]

I'm on over there now. Thanks