by Fabman » Sat Dec 10, 2022 12:30 pm
Sorry I feel like a deadbeat, never got back to see your reply. The reason I wanted to use something else was only because I was not used to it and always used post processor and g-code on my homebuilt machine. After using the cut & command software I really like it. Eliminating the post processor and g-code saves a lot of time for me and its much easier to use. Again sorry for not getting back with you.
Sorry I feel like a deadbeat, never got back to see your reply. The reason I wanted to use something else was only because I was not used to it and always used post processor and g-code on my homebuilt machine. After using the cut & command software I really like it. Eliminating the post processor and g-code saves a lot of time for me and its much easier to use. Again sorry for not getting back with you.