by Mfdchief » Sun Apr 01, 2018 12:24 pm
Hello,
I am having an issue with my command and cut software used on my tracker pro table all of a sudden. When you start a cut it flames out and doesn't finish the segment and will move to the next segment, it will do this for all of the segments in the project and never completely cut the project. All of the settings are the same that I have used for the last year and a half and haven't had any issues. Is their a known virus that could caused this? I have ran malware software and anti-virus software which have both completed and found 0 issues. Any help or suggestions would be appreciated.
Thanks,
Mark
Hello,
I am having an issue with my command and cut software used on my tracker pro table all of a sudden. When you start a cut it flames out and doesn't finish the segment and will move to the next segment, it will do this for all of the segments in the project and never completely cut the project. All of the settings are the same that I have used for the last year and a half and haven't had any issues. Is their a known virus that could caused this? I have ran malware software and anti-virus software which have both completed and found 0 issues. Any help or suggestions would be appreciated.
Thanks,
Mark